Ceiling Fan Remote Not Working Light

If the fan won t turn on and the lights are working then there is power to the fan.

Ceiling fan remote not working light.

A short or an overloaded circuit can cause the breaker to trip or turn off. So if the pull chain is in the off position the remote control will not be able to get any power to the ceiling fan light or fan. Check whether you have a faulty connection somewhere between the switch fan and circuit breaker. Check to see whether you have loose switch wiring.

Follow the steps below to determine the cause. Look inside of the light bulb socket to make sure there are no burn marks or charred spots. If you are using a remote or. In this case replace the reverse switch.

If you have an older ceiling fan the switch may be worn out. See the links below to go to the ceiling fan area for detailed photos and instructions. If the ceiling fan and light works normally then the remote control module will need to be replaced. Check the reversing switch.

They need to be set the same way on both the fan and the remote. If no light is visible then it is busted. The fan will turn on and light if applicable will blink three times signaling a successful synchronization. Flip the switch several times to make sure it is the right.

Check whether you have loose ceiling fan wiring. Should it become necessary to re sync the remote turn off the main power then turn it back on. Within 30 seconds use a small screwdriver to press and hold the learn button on the remote for 3 seconds. You can do this by pointing it towards the camera of your phone and then pressing and holding a button.

The light bulbs in the fixture are burnt out. The pull chain switches are in the wrong setting. The solution is to press the fan high button and then light on on the remote control unit and then pull the pull chains until the light comes on and the fan runs on high. Confirm the reverse switch is not in a neutral position.

If things look good return light bulbs that are in working order into their sockets. One way to know for sure would be to remove the receiver module at the ceiling fan and wire it direct. If you see black or burned areas this may be a sign that your ceiling fan light kit has a wiring issue. Screw them into.

In this case you will need to purchase a new remote and program it for the ceiling fan receiver. Make sure the switch isn t in between positions. The battery in the remote control needs replacing. This can usually be done by checking the dip switches.